Projet

Général

Profil

FTOS » Historique » Version 21

Version 20 (Laurent GUERBY, 05/01/2018 15:59) → Version 21/31 (Laurent GUERBY, 01/02/2018 23:26)

{{>toc}}

h1. FTOS

Dell/Force10 S4810 48 ports 10G SFP+ + 4 ports 40G
supporte cumulus http://cumulusnetworks.com/static/cumulus/pdf/Cumulus_Networks_Dell_Datasheet.pdf
http://cumulusnetworks.com/

* ssh keys
http://www.force10networks.com/CSPortal20/TechTips/0006_RSA-SSH.aspx

https://www.dell.com/support/article/fr/fr/frbsdt1/how10657/how-to-manage-the-qsfp-ports-on-a-force10-s4810-switch?lang=en

h2. Commandes

screen -m -c /dev/null /dev/ttyUSB0 9600 8n1

dir
delete flash://startup-config
reload
no
yes

en exec
stop jumpstart
wr

username force10 password force10
enable password force10
wr

portmod hybrid
switchport
int vl 2
unttagged t0/23
int vl 3
tagged t0/23

show vlan

stack-unit 1 renumber 0
no
yes

show inventory media

ip ssh server enable

show mac-address-table dynamic
show mac-address-table dynamic vlan 3132

<pre>
show interface tengigabitethernet 0/47 transceiver
...
SFP+ 47 Temperature = 41.902C
SFP+ 47 Voltage = 3.287V
SFP+ 47 Tx Bias Current = 34.012mA
SFP+ 47 Tx Power = 0.519mW
SFP+ 47 Rx Power = 0.451mW
</pre>

<pre>
FTOS#sh int status
Port Description Status Speed Duplex Vlan
Te 0/0 Down Auto Auto 1,3131,3175,3199
Te 0/1 Up 10000 Mbit Full 1,20,128,666,3118,3131,3175,3199
Te 0/2 Up 10000 Mbit Full 3188
Te 0/3 Down Auto Auto 3188
Te 0/4 Up 10000 Mbit Full 3188
Te 0/5 Up 10000 Mbit Full 3188
Te 0/6 Down Auto Auto 3188
Te 0/7 Up 10000 Mbit Full 3188
Te 0/8 Up 10000 Mbit Full 3188
Te 0/9 Up 10000 Mbit Full 3188
Te 0/10 Down Auto Auto 3188
Te 0/11 Down Auto Auto 3188
Te 0/12 Up 10000 Mbit Full 1,3131-3132,3175,3199
Te 0/13 Up 10000 Mbit Full 1,3131-3132,3175,3199
Te 0/14 Up 10000 Mbit Full 1,3131-3132,3175,3199
Te 0/15 Up 10000 Mbit Full 1,3131-3132,3175,3199
Te 0/16 Down Auto Auto 1,3131-3132,3175,3199
Te 0/17 Up 10000 Mbit Full 1,3131-3132,3175,3199
Te 0/18 Up 10000 Mbit Full 1,3131-3132,3175,3199
Te 0/19 Down Auto Auto 1,3131-3132,3175,3199
Te 0/20 Up 10000 Mbit Full 1,3131-3132,3175,3199
Te 0/21 Up 10000 Mbit Full 1,3131-3132,3175,3199
...
</pre>

<pre>
FTOS#sh interfaces switchport tengigabitethernet 0

Codes: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Trunk, H - VSN tagged
i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT tagged

Name: TenGigabitEthernet 0/0
802.1QTagged: Hybrid
Vlan membership:
Q Vlans
U 1
T 3131,3175,3199

Native VlanId: 1.

Name: TenGigabitEthernet 0/1
802.1QTagged: Hybrid
Vlan membership:
Q Vlans
U 1
T 20,128,666,3118,3131,3175,3199

Native VlanId: 1.



Name: TenGigabitEthernet 0/2
802.1QTagged: Hybrid
Vlan membership:
Q Vlans
U 3188

Native VlanId: 3188.
...
</pre>

<pre>
FTOS#sh interfaces tengigabitethernet 0
TenGigabitEthernet 0/0 is up, line protocol is down
Hardware is DellForce10Eth, address is 00:01:e8:8b:4f:cf
Current address is 00:01:e8:8b:4f:cf
Pluggable media not present
Interface index is 33883138
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed auto
Flowcontrol rx on tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 80w0d1h
Queueing strategy: fifo
Input Statistics:
0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 80w0d1h


TenGigabitEthernet 0/1 is up, line protocol is up
Hardware is DellForce10Eth, address is 00:01:e8:8b:4f:cf
Current address is 00:01:e8:8b:4f:cf
Pluggable media present, SFP+ type is 10GBASE-CU5M
Medium is Twinax Copper
Interface index is 34145282
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 10000 Mbit
Flowcontrol rx on tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 80w0d1h
Queueing strategy: fifo
Input Statistics:
77846344701 packets, 33998273797981 bytes
4710063270 64-byte pkts, 40824319413 over 64-byte pkts, 9871182555 over 127-byte pkts
3982474520 over 255-byte pkts, 684219485 over 511-byte pkts, 17774085458 over 1023-byte pkts
64436920 Multicasts, 108058987 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
100565862739 packets, 85221880135780 bytes, 0 underruns
5520274128 64-byte pkts, 32394947465 over 64-byte pkts, 5238057644 over 127-byte pkts
2670375206 over 255-byte pkts, 2001008247 over 511-byte pkts, 52741200049 over 1023-byte pkts
300101222 Multicasts, 601777166 Broadcasts, 99663984351 Unicasts
0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 217 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 237 packets/sec, 0.01% of line-rate
Time since last interface status change: 1w5d1h
...
</pre>



h2. Switch Openstack

On se logue

<pre>
enable password force10
conf
</pre>

Preparation des ports

<pre>
int range tengigabitethernet 0/0 - 47
no switchport
portmod hybrid
switchport
no shut

int range fortyGigE 0/48 - 60
no switchport
portmod hybrid
switchport
no shut

# Pour le port uplink
int range tengigabitethernet 0/1
speed 1000
</pre>

Pour un seul port :
<pre>
enable
conf
int t0/10
speed 1000
exit
exit
wr
# ou do wr
</pre>

Au cas ou "no negotiation auto" peut aider (cas des SFP bidi alturna CISCO) :

<pre>

FTOS(conf-if-te-0/16)#negotiation ?
auto Perform link autonegotiation
FTOS(conf-if-te-0/16)#speed ?
10 10 Mbps
100 100 Mbps
1000 1000 Mbps
10000 10000 Mbps
auto Auto negotiation (default)
</pre>

Creation des vlans
<pre>
int vlan 3131
no shut

int vlan 3175
ip address 192.168.3.48/24
no shut

int vlan 3195
no shut

int vlan 174
no shut
</pre>

Ajout des ports au vlan
<pre>
int vlan 3131
tagged tengigabitethernet 0/1
tagged tengigabitethernet 0/5
tagged tengigabitethernet 0/7
tagged tengigabitethernet 0/9

int vlan 3132
tagged tengigabitethernet 0/1
tagged tengigabitethernet 0/5
tagged tengigabitethernet 0/7
tagged tengigabitethernet 0/9

int vlan 3175
tagged tengigabitethernet 0/1
tagged tengigabitethernet 0/5
tagged tengigabitethernet 0/7
tagged tengigabitethernet 0/9

int vlan 3199
tagged tengigabitethernet 0/1
tagged tengigabitethernet 0/5
tagged tengigabitethernet 0/7
tagged tengigabitethernet 0/9

</pre>

Pour le TouIX untagged 4031

<pre>
FTOS>enable
FTOS#conf
FTOS(conf)#int vlan 4031
FTOS(conf-if-vl-4031)#no shut
FTOS(conf-if-vl-4031)#description TouIX
FTOS(conf-if-vl-4031)#untagged tengigabitethernet 0/35
FTOS(conf-if-vl-4031)#exit
FTOS(conf)#wr
</pre>

Detruire un vlan
<pre>
no int vlan2
</pre>

Enlever un port d'un vlan
<pre>

int vlan 2
no tagged tengigabitethernet 0/1
</pre>

Configuration routage
<pre>
ip route 0.0.0.0/0 192.168.3.47
</pre>

Configuration du logging
<pre>
logging 91.224.149.152
</pre>

Fabrication port bonding

<pre>
- enable
- conf
- int tengigabitethernet 0/46
- port-channel-protocol lacp
- port-channel 10 mode active
- no shut

- int tengigabitethernet 0/47
- port-channel-protocol lacp
- port-channel 10 mode active
- no shut
- exit

- int port-channel 10
- sw
- no shut
- end
- wr
</pre>

tcpdump
<pre>
FTOS#tcpdump cp packet-count 10
% Copy operation not allowed until the TCP dump completes %
FTOS#dir flash:/TCP_DUMP_DIR/Tcpdump_141014021344/
</pre>