{{>toc}}

h1. AirOS

http://www.ubnt.com/wiki/RF_Compliance

For example, if you select 5805 MHz (40 MHz channel) and Below, the radio will use (5775 to 5795 MHz) + (5795 to 5815 MHz),
but if you select 5805 MHz (40 MHz channel) and Above, the radio will use (5795 to 5815 MHz) + (5815 to 5835 MHz).

h2. v5.3.5

http://wiki.ubnt.com/AirOS_5.3

Channel width 5/10/20/40

TX power min max dBm
Loco 4 23
NS 8 27
NB 4 23
Rocket -4 27

LocoM2 5/10/20/40 dBm 5-23

h2. v5.5

http://www.ubnt.com/download#doc
http://www.ubnt.com/downloads/guides/airOS/airOS_UG_V55_3-20-12.pdf

Country Compliance Mode Frequency 4920 Mhz a 6100 MHz
Channel width 3/5/8/10/20/25/30/40

TX power min max dBm
Loco 4 23
NS -4 27
NB -8 23
Rocket -4 27

LocoM2 3/5/8/10/20/25/30/40 dBm 5-23 Freq 2312 a 2732 MHz

IPv6 supported in command line ping6 fe80::xxx%br0 works

h2. AirView test

Lab on table same room compliance mode 5.5
- one NSM5 AP WDS
- one LocoM5 STA WDS 1 meter from the NSM5
- one NBM5 head (without dish) right in between Loco and NS running AirView

Steps for each graph
# associate NS and Loco with new frequency and width
# clear airview
# launch 300 second iperf client between netbook behind NSM5 to iperf server on locoM5
# after iperf is done save airview screenshot
# go back to step 1

h3. First batch testing narrow channels 5240 with 5200-5300 airview:

* 3 MHz
!5240-3.png!
* 5 MHz
!5240-5.png!
* 8 MHz
!5240-8.png!
* 10 MHz
!5240-10.png!
* 20 MHz
!5240-20.png!

h3. Second batch testing large channels 5300 with 5200-5400 airview:

* no emission to verify noise
!5300-0b.png!
* 10 MHz
!5300-10b.png!
* 20 MHz
!5300-20b.png!
* 30 MHz
!5300-30b.png!
* 40 MHz
!5300-40b.png!